Structural steel · HubSpot

From steel plan set to HubSpot quote

RenderDraw proposes structural steel quantities from plan and design drawings, tied to the source sheet and member tag. Your estimator reviews flagged exceptions and approves the takeoff. Use the reviewed rows to prepare a HubSpot quote on the deal, with CSV or XLSX as the portable handoff.

Try it with your drawings
Steel frame model on a plan set beside stacked amber sheets
Illustration: review the structural quantities before preparing the deal quote.

Who this is for

Steel fabricators, erectors, detailers and specialty subs who already run sales in HubSpot, but still do the takeoff in Bluebeam or Excel and then key it into a quote by hand. If your estimator and your sales rep are both typing the same beam list, this is the page.

Where the handoff breaks

When the estimator marks up a PDF and sales retypes the quantities into a deal quote, addenda can leave the takeoff and quote out of sync. Keep sheet and member references with the approved quantities so the quote can be checked against the right drawing revision.

How the workflow runs

  1. Upload. Start with the structural PDF plan set and identify the drawing revision.
  2. Extract. Steel quantities come back with confidence and source coordinates, tied to sheet and tag on plan drawings.
  3. Review. Low-confidence items and odd scope go to the estimator. They review the exceptions, correct quantities as needed, and approve the takeoff. They can review any item before approval.
  4. Map. Match approved rows to the right products, quantities, and units in HubSpot.
  5. Prepare the quote. Use the approved lines to prepare the quote on the deal. Use CSV or XLSX if your portal does not have a verified connection for quote creation.
Structural plans and a steel section sample next to a draft quote packet
Keep the approved takeoff separate from product mapping and quote pricing.

What to carry into the HubSpot quote

Use the approved member identifier, quantity, and unit to map each line to the corresponding HubSpot product or line item. Keep the source sheet and tag in the reviewed takeoff for audit and revision checks. Confirm the deal, pricing, and units before sending the quote.

Where the estimator stays in charge

The estimator approves scope and quantities before sales prepares the quote. Verify portal permissions and field mapping before relying on an automated quote connection. CSV and XLSX work as a handoff when that connection is unavailable.

Drawing and integration limits

  • Tag reading works on plan and design drawings, not as-builts.
  • No PowerFab write, Accubid, FastEST or Procore connector claimed here.

Frequently asked questions

Does the estimator still approve the steel takeoff?

Yes. RenderDraw flags low-confidence quantities and unusual scope for review. The estimator reviews those exceptions and approves the takeoff before any quote is created.

Does RenderDraw create the HubSpot quote?

Direct creation depends on a configured HubSpot portal with verified quote-write permissions and field mapping. If that path is unavailable, export the approved quantities and prepare the quote on the deal in HubSpot.

What if my shop is on Salesforce instead?

Use the steel takeoff to Salesforce quote workflow. That page covers Salesforce Quotes and CPQ pricing. This page is for shops that quote in HubSpot.

Does it read piece marks?

On plan and design drawings, takeoff lines tie back to the sheet and the steel tag. As-built drawings are not supported for tag reading.